This Product is for sale in US Border Towns, Mexico and Central America

• High Power Density
  3 kW and 4 kW models, 2U (3½ inches) high, 19 inches wide; no top or bottom clearance spacing required
• Wide Range of Output Voltages
  3 kW and 4 kW outputs 0-5V, 8V, 16V, 32V, 40V, 60V, 80V, 150V, 300V and 600V
• Preview Pushbutton
  Overvoltage protection (OVP), voltage and current preview buttons allow viewing these set points at any time with or without the output enabled
• Remote Voltage Sense
  Sense leads are easily connected to a solderless connector
• Remote Operation
  - Standard analog programming
  - Output enable/disable remotely
  - Optional IEEE-488.2 and RS 232
  - Optional optically isolated analog programming
• Calibration
  All models can be calibrated without removing the covers
• Operating Modes
  Constant voltage and constant current, with LED indicators
• Parallel or Series Operation
  Field configurable
• Input Power Factor
  0.95 typical (three phase for all models) 0.98 typical (single phase)
• CE Mark, UL and C-UL Listing Mark
• 5 Year Warranty

The DLM 3 kW and 4 kW Series programmable DC power supplies are designed to provide highly stable, continuously variable output voltage and current for a broad range of applications in a compact 2U ( 3½” high) chassis.

The 4 kW power rating is new to the Sorensen Family of power supplies. Both the 3 kW and
4 kW models have output voltages from 0-5 VDC to 0-600 VDC and a current range from 0-5A to 0-450A. The output RMS noise is as low as 10 mV. The output will recover to 1% of its steady-state voltage within 1 ms for a step load change of 100% to 70% or 70% to 100%. The front panel layout makes the series extremely easy to use. Control switches include: power on, enable/ standby and local/remote.

Displays and indicators show programmed set points and operational control status. The programmed voltage, current and overvoltage set points are displayed with two large 3½ digit LED displays. Operational Status LEDs indicate power on, shutdown, overtemperature, overvoltage, constant current and voltage mode status. Control Status LEDs indicate front panel lockout, remote control and standby status. IEEE-488.2 control LEDs indicate error, service request and remote address status.

The 3 kW Models will accept 200*/230 VAC single phase and 200*/208 VAC three phase input power.

The 4 kW Models will accept 200*/208 VAC, three phase or optional 400 or
480 VAC three phase input power.

*Operating temperature below 40°C