200 MHz Bandwidth

4  Input Channels

1 GS/s Real Time Sampling Rate & 25 GS/s Equivalent-Time Sampling

25 kpoints Record Length Maximum

Large 5.6-in TFT Color Display

FFT Function

Standard USB Host and Device Interface; Optional GPIB

Optional DC Power

Includes:

• 128 MB USB Storage Device
• Switchable Passive Probe
• Instruction Manual
• Power Chord
• NIST Certification

SPECIFICATIONS
Vertical	GDS-2062/2064 GDS-2102/2104 GDS-2202/2204 Channels 2 / 4 2 / 4 2 / 4 Bandwidth DC - 60 MHz (-3 dB) DC - 100 MHz (-3 dB) DC - 200 MHz (-3 dB) Rise Time 5.8 ns Approx. 3.5 ns Approx. 1.75 ns Approx.
	Sensitivity 2 mV/div~5V/div (1-2-5 increments) Accuracy ｱ(3% x [Readout] + 0.05 div x Volts/div Input Coupling AC, DC, & Ground Input Impedance 1 Mｱ2%, -16 pF Polarity Normal & Input Maximum Input 300 V (DC + AC peak), CATII Waveform Signal Process + , - , x , / , FFT Offset Range 2 mV/div ~ 20 mV/div : ｱ0.5V; 50 mV/div ~ 200 mV/div:ｱ5V; 500 mV/div ~ 2 V/div : ｱ50 V; 5 V/div: ｱ300V Bandwidth Limit 20 MHz (-3 dB)
Trigger	Sources CH1 , CH2 , Line , EXT(2CH Only) / (CH3,CH Modes Auto-Level, AUTO, NORMAL, SINGLE, TV, Edge, Pulse Width Time-delay(2CH Only), Event-delay(2CH Only) Coupling AC , DC , LF rej. , HF rej. , Noise rej. Sensitivity DC ~ 25MHz : Approx. 0.5div or 5mV 25MHz ~ 60/100/200MHz : Approx. 1div or 10mV
Horizontal	Range 1ns/div ~ 10s/div (1-2-5 increments); ROLL : 250ms/div ~ 10s/div Modes MAIN, WINDOW, WINDOW ZOOM, ROLL, SCAN, X-Y Accuracy ｱ0.01% Pre-trigger 20 div maximum  Post-Trigger 1000 div
Signal Acquisition	Real-Time Sample Rate 1 GS/s Equivalent Time Sample Rate 25 GS/s Vertical Resolution 8 Bits Record Length 25K Dots Maximum Single Shot Bandwidth 100 MHz Acquisition Mode Sample, Peak Detect, Average, Accumulate Peak Detection 10 ns Average 2 ・4 ・8 ・16 ・32 ・64 ・128 ・256
Display	TFT LCD Type 1ns/div ~ 10s/div (1-2-5 increments); ROLL : 250ms/div ~ 10s/div Display Resolution MAIN, WINDOW, WINDOW ZOOM, ROLL, SCAN, X-Y Display Graticule ｱ0.01% Display Brightness 20 div maximum
Interface	GO/NO GO Output Open Collector RS-232 DB 9-pin male DTE RS-232 interface USB Host: Pen Drive ・Printer; Device: Support remote control GPIB (optional) Fully programmable with IEEE488.2 compliance
Power Source	Line Voltage Range 100 V ~ 240 VAC 48 Hz ~ 63 Hz, Auto select Battery Power (opt.) Battery: 10.8 V Li Ion battery pack     Charge Time: 12 hours from AC Line Operating Time: 3 hours, depending on operating condition